does any know where you can get dents pulled out of a head pipe and how much it ruffley costs.. thankyou

-- Edited by crman818 at 18:36, 2009-02-05

need help

idk but i heard that if you put tape at one end fill the head with water tape the other end and put it in a freezer and let it freeze it will pop the dents out. don't know how good it works but worth the shot do it a few times, make sure you dump out the water after each time you thaw it out

ok thanks.

i bought a dent puller at advanced auto parts and its a thing where you hot glue a suction cup on and then move the pullers out and it pulls them right out, works real nice and it was cheap...

thanks il try it

if this is for your two stroke dont do the freezing water thing.. thats only for four stroke headers it could break the welds on your two stroke pipe. Heat up the dent with a torch and fill the pipe with compressed air and it should pop it out.

alright thanks kevin i need to get a couple head pipes pulled. have you done the compressed air one yet?

I personally havent but you can go to like napa or probably a hardware store and get a rubber plug and plug it up and i think you really only need like 10-15lbs of pressure im not 100% sure. But its really important that you heat up the dented area really well.

screw that i say put a whole new one on for the amount of money you got! lol

lol ik thats what i did. but i stil want to get the dent out of my extra fmf